How To Fix a Failed Linksys Wireless Router Set-up

It is very important for a person to have internet connection these days. Most people are online at least for a major part of their working time. These days, it is even possible for you to have many computers connected to the internet because of the WiFi facilities available. These are wireless connections that make it easy for the internet user and give them to move around within the area that is WiFi enabled. One of the most common methods that is used to connect to the internet wirelessly is through the Linksys wireless system.

If the Linksys wireless system does not work, then you will be in a soup. This is because till you get the whole system back on track, you will have major problems. There are certain methods that you can use as tips to get the system up and functioning again. Trouble shooting in times when the Linksys wireless system does not work will help you to rectify the fault.

The first step that you need to take in the process of getting the router working is that you will have to turn on the router and then make sure that you press the reset button on the router for about 30 seconds. You may find it difficult to press the reset button with your fingers and so you can use a pencil tip to reset. You can also remove the router and reconnect it after a few seconds.

Another thing that has to be done is to remove the DSL connection to the computer and then connect the modem to the first port on the router. Once this is done, you should reset the router again and start the browser of the computer. Once this is done, you can add the address in the address bar of the browser. Once you have done this, you are asked to log into the system. In this, though you do not need a username to log in, you should have a password. The usual default password is admin. Once this is done, you should also make sure that you clone the MAC on the PC.

All these processes may take some time and so once this is done, you should enter the Setup and again change the LAN address to After you save the settings, make sure that you remember what you have done as it will help you to make needed adjustments later. The final step is to shut down the system for a full two minutes. Once the system and the router are restarted, they should usually work. If the system works, you should put the system off again along with the router.

After this is done, you should connect and start the DSL modem. The next step is to turn on the router and then finally the PC is turned on. These steps should make you online and because the whole system is wireless, you will be able to work on the internet in any place within the WiFi enabled area.

Leave a Reply

Your email address will not be published. Required fields are marked *